Hardware
Equipment, Error Codes, Tech Specs
39 articles
- Operating Glambot® and Snappic With Only One iPad
- iPad Dual Band Wired Network Control
- No USB power / No USB data provided from arm 2 (Event Pro 3)
- Assembly & Disassembly Instructions: Event Pro 3
- How to Install Glambot® Safety Sensor
- Glambot not calibrating
- Charging iPad While Using A Wired Camera Connection
- Shoulder Cover Installation Guide
- Manually moving arm 1 to neutral position using the reset switch (Event Pro 3/Event Pro 4 Models)
- Using your 24V power supply (Event Pro 1 & 2)
- Wrist full rotation / Won’t stop rotating at the end of a path
- Glambot® Wi-Fi Network Not Found
- Wrist Position Off-Center
- Cable Replacement: Gray USB
- Blue Cue Light Won't Turn On
- Glambot® Arm Falling to the Ground
- Using a Wired Touchscreen Monitor for Motion Control Software
- Operating Glambot® and Snappic With Two iPads/iPhones
- Path Movements
- Factory Upgrade: Event Pro 2 → Event Pro 4
- DIY Upgrade Kit: Event Pro 3 → Event Pro 4
- Pin Connector Replacement
- E01 Webapp Error
- E11 Bluetooth Communication Error / Bluetooth not showing up / Cannot connect to Bluetooth
- E12 Wrist communication error
- E13 Wrist 1 Error
- E14 Stepper Communication Error
- E15 Stepper Connection Error
- E16 Stepper Setup Error
- E17A / E17B Motor Engagement Error
- E18 Motor Communication Error
- E17D Pan Motor Setup Error
- E17D Elbow Motor Error
- E21 Wrist runtime error
- E22 Motor Error