NOTE: Please read each step thoroughly before completing it.
Locate the velcro pads on each side of the inner shell. Remove the liner to prepare the adhesive for alignment to the shoulder joint.
Pull open the velcro end of the shell slightly to avoid prematurely sticking the velcro adhesive. Then slide the cover up to the housing and down around the components until aligned with the curve of the housing. Refer to Step 3 for alignment.
Apply additional pressure at the 2x velcro pad locations and hold for 5 seconds to ensure proper adhesion.
To remove the cover, pull open the shell at the velcro locations to disengage the velcro and slide off.
