If the Glambot (Event Pro 1 or Event Pro 2) is stuck in a position outside of the neutral extended position, follow these steps to move it manually with the 24v power supply:
Rotate the arm so that it is facing forward in line with the base of the unit
Locate the brake connector
Disconnect cable 16
Connect the 24v power supply
While supporting arm 1 (the section with the Glambot® logo), turn on the power
Carefully lower the arm until it's at a 90° angle to the pedestal, then turn the power off and disconnect the 24v power supply
Reconnect cable 16
Ensure arm 2 is at a 90° to arm 1 and the wrist is slightly tucked back towards the base of the unit
Restart the system