Installing the GoPro Cage and Cover on the Glambot® Wrist End Efffector

Install the GoPro Adapter to the Wrist coupler with (2) M3x10mm socket cap screws using a 2.5mm hex key.

Slide the GoPro cage into the GoPro adapter and fasten with the (1) included M5x6mm button head screw using a 3mm hex key.

Slide the back cover off the cage and insert the GoPro. Then slide the Video Light onto the cage at the cold shoe location and secure with the double thumb nuts.

Install the (2) M3x6mm button head screws partially into the GoPro cage side mounting holes. Then, slide the plastic cover over the assembly with the slot wall behind the pre-installed screws. Tighten the screws with a 2mm hex key through the side access hole.

Snap the Rear Cover into the mounted Front Cover.